login status

(close)
 

Pocket Door Hardware

Pocket Door hardware is installed inside the studs of an unfinished wall so the door can tuck into the wall when closed. Pocket Door Hardware is used when there isn’t room for a swinging or sliding door. It can be used often as a bathroom door.

Single Pocket Door Configuration

Converging Pocket Door Configuration

Reeb orders all Pocket Door Hardware from LE Johnson: the 1500 Knocked Down Series, the 2711 Pre-Assembled Series, and the 2710 Pre-assembled series. The 1500 series is avialable in a wide array of sizes but is also notched for proper field trimming for uncommon standard door sizes. The 2710 and 2711 series make it easy to install as the frames are already built and ready to go into the wall. The options for sizes are limited for these as Reeb only stocks a 6/8 height option.

Pocket door hardware kits work with 4-9/16″ jamb depths through Reeb’s stock, but other jamb depth sizes are available as special order. Reeb’s pocket door hardware is set up for a single door application. By using a Converging Kit, it can also be set up for a double door application.

For more information on the 1500 series, please click here.

For more information on the 2710 series, please click here.

For more information on the 2711 series, please click here.

Updated on November 4, 2020

Was this article helpful?